L750 Lancer Coil Cut Off Machine

L750 Lancer Coil Cut Off Machine

The L750 Lancer Coil Cut Off Machine is a vertical motor coil cutting machine that drastically reduces the manual labor hours of the hammer and chisel method.

The machine has the capability of running two speeds which increases cutting efficiency, by allowing the machine to match spindle speed to wheel diameter.

The L750 Lancer Coil Cutoff Machine was developed in actual repair shop conditions, which is why it is a benefit to the motor repair industry. The specialized design is made specifically to accommodate small repair shops and large companies that are looking to expand their motor stripping/ extracting capabilities. Over 1,000 motor repair shops throughout the United States and Canada, as well as the U.S. Army, Navy and the National Guard have purchased this machine and are experiencing the benefits.

L750 Lancer Machine Models 

L750-1-Single Phase- Voltage Options
• (110 /115/120 |220/230/240)
• 3 HP | 3600 RPM | 60 HZ
• Foot switch
• Face mask
• Abrasive Cutting Wheels Included


L750-2-Manual Machine:
• Buyer Adds Motor of Their Choice


L750-3-Three Phase- Voltage Options
• (110 /115/120 | 220/230/240)
• 3 HP | 3600 RPM | 60 HZ
• Footswitch
• Face mask
• Abrasive Cutting Wheels Included


L750 Lancer Accessories:

Floor Mounted Turntable– Increase Motor Size Capability | Spinning Motion to Increase Mobility of Motor and Access to Coils

Spindle Extension– 6”- Increase Motor Size Capability

Power Lift Motor– The gear reduced drive raises and lowers the cutting arm smoothly and effortlessly| Eliminates time consuming hand cranking and operator fatigue |Reduce stator change over time and reduce labor costs with the flip of a switch

 

 

 L750 Lancer Benefits:

Reduce stripping time to minutes compared to hours with the hammer and chisel method
Typically investment can be completely recovered in less than a year


L750 Lancer Specifications:

Spindle Speed Options-6500 RPM | 8300 RPM
Swing Length- 59”
Starter- Magnetic with overload protection
Footswitch Control
Optional Floor Mounted Turntable to accommodate larger motors

Abrasive Cutting Wheel/Blade Diameter– 4” | 6” | 8”
Recommend Remgrit Abrasive Cutting Wheels/Blades

Approximate Weight: 325 lbs.
Approximate Dimensions: 32”W x 36”L x 60”H


L750 Lancer Capabilities:

Maximum Motor Frame Diameter – 36”
*With Floor Mounted Turntable-48”

Maximum Motor Frame Length – 20”
*With Floor Mounted Turntable-36”

Minimum Motor Frame Size– 48”
Maximum Reach-Outer Frame Edge to Stator Laminations– 6”